26/07/2023 16:56:36
Bracket - 2nd Row Floor Panel - Center (Without 2nd Row Bench Seats)
Correction Code 15303802
Removal
- Remove the LH and RH rear sill trim panels (refer to procedure).
- Remove the LH and RH lower C-Pillar trim panels (refer to procedure).
- Remove the 2nd row middle floor panel (refer to procedure).
- If equipped, remove the the foam blocks between the outboard and center 2nd row seats.
- Connect a laptop with Toolbox 3 to the vehicle.
-
Choose from the
following:
- Before removal: To enable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-ONvia Toolbox: (link), click Run, and allow the routine to complete.
- After installation: To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
- Move the 2nd row LH and RH seats fully forward.
-
Pull outward on the center
seat LH podium trim to release the clips that secure it to the seat.
CAUTIONReplace any broken clips.
-
Working from the LH side of the vehicle, pull outward on the center seat RH
podium trim to release the clips that secure it to the seat.
CAUTIONReplace any broken clips.
-
Using a pick or similar
tool, peel back the carpet from the front sliding panel to access the screws
underneath.
NoteThis carpet is a one time use component. Ensure that a new carpet is installed during reinstallation.
-
Remove the screws that
secure the front sliding panel to the seat tracks (torque 2.5 Nm).
-
Release the fasteners that
secure the center floor panel bracket.
Installation
Installation procedure is the reverse of removal.