09/11/2022 09:40:23

Power Strut - Liftgate (Remove and Replace)

Correction Code 11334202

Removal

  1. Open the liftgate.
  2. Open both rear doors.
  3. Power the 2nd row seats fully forward for access.
  4. Remove the LH C-pillar upper trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  5. Disconnect the power strut electrical harness connector.
  6. Release the grommet on the liftgate and pull the power strut harness and electrical connector out through the body cavity.
  7. Use a telescoping bar to support the liftgate in the open position.
    Tip: Position the support bar against the bracket for better support.
  8. Release the locking tab that attaches the top of the power strut to the body.
  9. Release the locking tab that attaches the bottom of the power strut to the body.
  10. Release the power strut from the ball joints.
  11. Remove the power strut from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

  1. If necessary, apply grease to the grommet before routing the power strut harness through the body cavity.
  2. Make sure that the liftgate opens and closes properly prior to installing the components that were removed for access.
  3. Move the 2nd row seats back to their original positions.