03/03/2020 13:18:43

Cable - Latch - Hood - Primary (Remove and Replace)

Correction Code 11352212

Removal

  1. Remove the front underhood storage unit (refer to procedure).
  2. Release the primary hood latch cable end from the latch.
  3. Use a trim tool to remove the tow hook cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the trim tool into the notch at the top right portion of the tow hook cover.
  4. Release the straps from the tow hook cover and move them through the tow hook opening.
  5. Remove the bolts (x3) that secure the actuator assembly bracket to the front end module (torque 10 Nm).
  6. Lift the actuator assembly bracket into a working position.
  7. Separate the manual release strap from the primary actuator assembly bracket retainer.
  8. Slide the black cap from the primary actuator onto the primary cable.
  9. Release the clip that secures the actuator clevis to the primary actuator, and then slide the clevis off of the actuator.
  10. Rotate the actuator clevis 90 degrees, and then slide the clevis off of the cable end.
  11. Move the primary cable through the slit in the side of the black cap, and remove the cap from the vehicle.
  12. Release the primary cable from the actuator assembly bracket, and then pass the end of the cable through the manual release lever.
  13. Release the clip that secures the primary cable to the latch bracket and remove the cable from the bracket.
  14. Release the edge clips (x3) that secure the primary cable to the front end module, and then remove the cable from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace any broken clips.

Installation

Installation procedure is the reverse of removal.