25/03/2024 17:27:36

Switch - 2nd Row Seat - Center (Remove and Replace)

Correction Code 13024302

Remove

  1. Open the rear doors.
  2. Move the LH and RH 2nd row seats fully rearward.
  3. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  4. Unlock the vehicle gateway. See Gateway Unlock.
  5. In Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-ONvia Toolbox: (link), click Run, and allow the routine to complete.
  6. Use a pick to release the plastic covers that conceal the screws on the bottom of the seat.
  7. Remove the screws that secure the plastic trim to the bottom of the seat frame.
  8. While holding down the plastic trim, remove the fasteners that secure the switch to the plastic trim.
  9. Disconnect the harness from the switch, and then remove the switch from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
  • After installation, use Toolbox 3 to disable seat install mode, and then test that the new switch functions properly.
    1. To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
    2. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).