03/03/2020 13:18:43
Antenna - Passive Entry - Front (Remove and Replace)
Correction Code 17451102
Removal
- Remove the HEPA filter duct (refer to procedure).
-
Move the coolant reservoir away from the working area:
-
Remove the screws (x2) that secure the front passive entry antenna to the bottom
of the front crossmember.
-
Disconnect the electrical connector from the passive entry antenna:
-
Use a trim tool to carefully release the passive entry antenna from the bottom
of the front crossmember.
- Remove the passive entry antenna from the vehicle.
Installation
Installation procedure is the reverse of removal, except for the following:
- Clean the mounting surface with alcohol wipes.
- Apply double sided tape to the passive entry antenna, if necessary.
- Loosely install the RH screw that secures the passive entry antenna.
-
Place the passive entry antenna against the screw so that the notch is flush
with the screw.
- Pivot the passive entry antenna so that it is in the desired location.
-
Fully install both screws that secure the passive entry antenna to the front
crossmember (torque 3.5 Nm).
NoteThe following image shows the electrical connector already connected.
- Apply firm pressure to the passive entry antenna for at least 15 seconds to ensure that the double sided tape is fully adhered to the front crossmember.
-
Connect the electrical connector to the passive entry antenna.
NoteRemember to push the red locking tab in.