22/12/2022 09:34:04

Seat Assembly - 2nd Row - LH (With 2nd Row Bench Seats) (Remove and Install)

Correction Code 13054001

Informational PurposesAn informational icon, calling your attention
Note
This procedure is applicable to 5-seat and 7-seat vehicles, but there may be minor differences in interior paneling between the two seating configurations.

Removal

  1. Open all the doors, the liftgate, and the hood.
  2. Move both front seats fully forward.
  3. Disconnect 12V power. See Disconnect 12V Power.
  4. Remove the 2nd row floor mat, if equipped.
  5. Fold down the LH 2nd row seat.
  6. Remove the LH and RH lower C-Pillar trim panels. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Remove the LH and RH lower side carpets.
  8. Remove the LH and RH rear sill trim panels. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  9. Remove the 2nd row middle floor panel. See Floor Panel - 2nd Row - Middle (Remove and Replace).
  10. Remove the foam blocks that support the center floor panel.
  11. Disconnect the seat harnesses.
  12. Release the clip that secures the harness to the LH floor panel bracket.
  13. Release the fasteners that secure the LH 2nd row seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    The next steps require an assistant.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  14. Remove the seat from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Install the seat fasteners in the following order:
  1. Install and hand-tighten the forwardmost seat track bolts (x2). The forward bolts are torqued in a later step.
  2. Use the Easy Entry button to move the rear seat fully forward to access the rear portion of the seat track.
  3. Install the centermost seat track bolts (x2) (torque 45 Nm).
  4. Install the outermost seat track bolts (x4) (torque 45 Nm).
  5. Use the Easy Entry button to move the rear seat fully rearward to access the forward portion of the seat track. Make sure the seat is in the locked position in the track.
  6. Torque the forwardmost seat track bolts (x2) (torque 45 Nm).
  7. Install the remaining seat track bolts (x4) (torque 45 Nm).