02/03/2020 13:50:14

Window Regulator - Front - LH - Recalibrate

Correction Code 11502000

Informational PurposesAn informational icon, calling your attention
Note
Perform both the De-Calibration and Calibration sections of this procedure.

De-Calibration

  1. Open the door that has the affected window.
  2. Fully raise the window.
  3. Use a pen or screwdriver shaft to manually latch the door while it is open.
    Informational PurposesAn informational icon, calling your attention
    Note
    The latch is fully closed when it clicks twice.
  4. Use the interior or exterior door handle to unlatch the door.
  5. Press the window switch down to the second position to activate the auto-lower function.
    • If the window lowers slightly, the regulator has been decalibrated. Skip to the Calibration section.
    • If the window lowers completely, continue to the next step.
  6. Repeatedly activate auto-reverse on the affected window:
    1. Enter the vehicle and close the door.
    2. Hold a non-marring tool below the upper window seal. Raise the window so that it contacts the tool and automatically reverses.
    3. Repeat the previous sub-step 14 times.

Calibration

Informational PurposesAn informational icon, calling your attention
Note
Perform the steps in the De-Calibration section before continuing.
  1. Enter the vehicle and close the door.
  2. Lower the window fully, and continue to hold the window switch down for 2 seconds after the window stops.
  3. Raise the window fully, and continue to hold the window switch up for 5 seconds after the window stops.
  4. Press the window switch down to the second position to activate the auto-lower function.
    • If the window lowers completely, the regulator is properly calibrated. Discontinue this procedure.
    • If the window does not lower completely, repeat step 6 of the De-Calibration procedure, then perform the Calibration procedure again.