26/07/2023 16:48:49

Module - Seat Memory - Front Seat (Remove and Replace)

Correction Code 13010602

Removal

  1. Raise the LH front seat.
  2. Disconnect 12V power (refer to procedure).
  3. Remove the lower seat trim.
  4. Disconnect the harnesses from the seat memory module.
  5. Release the module from the seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    In some vehicles, the module is secured with fasteners (torque 5 Nm).

Installation

Installation procedure is the reverse of removal, except for the following:
  1. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  2. Unlock the vehicle gateway. See Gateway Unlock.
  3. To disable seat install mode, in Toolbox 3, click the Actions tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFFvia Toolbox: (link), click Run, and allow the routine to complete.
  4. Choose from:
    • If replacing the memory seat module on the driver seat: To calibrate the driver seat, in Toolbox 3, click the Actions tab, type "PROC_MSMD" into the search field, click PROC_MSMD_VCSEATD-FRONT-DRV_CALIBRATE-MEMORY-SEATvia Toolbox: (link)via Service Mode: Low Voltage ➜ Seats ➜ Calibrate Driver Seat, click Run, and allow the routine to complete.
    • If replacing the memory seat module on the front passenger seat:
      1. In Toolbox 3, click the Actions tab, type "Sensor-Rezero" into the search field, click PROC_OCS_FRONT-PAS_SENSOR-REZEROvia Toolbox: (link), click Run, and allow the routine to complete.
      2. To calibrate the front passenger seat, in Toolbox 3, click the Actions tab, type "PROC_MSMP" into the search field, click PROC_MSMP_VCSEATP-FRONT-PAS_CALIBRATE-MEMORY-SEATvia Toolbox: (link)via Service Mode: Low Voltage ➜ Seats ➜ Calibrate Passenger Seat, click Run, and allow the routine to complete.
  5. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).