Week Ending December 21, 2024

The following procedure(s) were updated:

1. Compressor (Remove and Replace) - Added Note on separately adding correction code 18200102.
2. Condenser (Remove and Replace) - Added Note on separately adding correction code 18200102.
3. Pipe - High Pressure - Compressor to Condenser (Remove and Replace) - Added Note on separately adding correction code 18200102.
4. Pipes - High/Low Pressure - Condenser to Chiller (Remove and Replace) - Added Note on separately adding correction code 18200102.
5. Pipes - High/Low Pressure - Charge Port to Rocker (Remove and Replace) - Added Note on separately adding correction code 18200102.
6. Pipes - High/Low Pressure - Rocker (Remove and Replace) - Added note on separately adding CC 18200102
7. Pipes - High/Low Pressure - Rocker to Rear HVAC (Remove and Replace) - Added Note on separately adding correction code 18200102.
8. Sensor - Pressure and Temperature - High Pressure (Remove and Replace) - Added Note on separately adding correction code 18200102.
9. Sensor - Pressure and Temperature - Low Pressure (Remove and Replace) - Added Note on separately adding correction code 18200102.
10. TXV Valve - Evaporator - Front (Remove and Replace) - Added Note on separately adding correction code 18200102.

Week Ending December 14, 2024

The following new procedure(s) were added:

1. New glass components (windshield, roof, door, and fixed glass) must be inspected before installation to meet Tesla’s internal standards of quality. The Pre-Installation Glass Inspection procedure explains how to inspect new windshield, roof, door, and fixed glass components before the new component is installed.

The following procedure(s) were updated:

1. Added a new caution about Pre-Installation Glass Inspection service requirements:
   • Door Glass - LH - Front (Remove and Replace)
   • Door Glass - LH - Rear (Remove and Replace)
   • Door Glass - Rear - Upper - LH (Remove and Replace)
   • Fixed Glass - Front Door - LH (Remove and Replace)
   • Fixed Glass - Rear Door - LH (Remove and Replace)
   • Glass - Rear Quarter Window - LH (Remove and Replace)
   • Liftgate Glass (Remove and Replace)
   • Windshield (Vehicles with 1st Generation Autopilot Hardware) (Remove and Replace)
   • Windshield (Vehicles with 2nd Generation or Later Autopilot Hardware) (Remove and Replace)
2. Base Assembly - Driver Seat (Remove and Replace) - Added mini-tilt motor configuration information.
3. Removed note to add 00040100. FRT now includes test drive.
   • Four Wheel Alignment Check and Adjust

Week Ending December 7, 2024

The following procedure(s) were updated:

1. Bushing Carrier - Front Drive Unit (2nd Generation) (Remove and Replace) - Added info on FUCA ride height tool for EMEA.
2. Control Arm - Upper - Front - LH (Remove and Replace) - Added info on FUCA ride height tool for EMEA.
3. Control Arm - Upper - Front - RH (Remove and Replace) - Added info on FUCA ride height tool for EMEA.
4. Inverter - Front Drive Unit (Remove & Replace) - Added info on FUCA ride height tool for EMEA.
5. Link - Fore - Lower - Front - LH (Remove and Replace) - Added info on FUCA ride height tool for EMEA.
6. Links - Fore - Lower - Front - LH/RH (Remove and Replace) - Added info on FUCA ride height tool for EMEA.
7. Seat Assembly - 1st Row - LH (Remove and Replace) - Added configuration information for seat assemblies with the mini-tilt motor.
8. Seat Assembly - 1st Row - RH (Remove and Replace) - Added configuration information for seat assemblies with the mini-tilt motor.
9. Wiper Module (Remove and Replace) - Updated procedure to latest procedure validation.

Week Ending November 30, 2024

The following procedure(s) were updated:

1. Cooling System - Vacuum Refill - Added images of vacuum refill tool setup and added warning on incorrect use of the refill tool.

Week Ending November 23, 2024

The following procedure(s) were updated:

1. Battery - Auxiliary - 12V (Remove and Replace) - Added a note to remind of checking the 12V/LV battery temperature before performing the procedure.

Week Ending November 16, 2024

The following new procedure(s) were added:

The following procedure(s) were updated:

1. Steering Rack (LHD RWD) (1st Generation) (Remove and Replace) - Updated firmware install step.
2. Steering Rack (LHD Dual Motor) (1st Generation) (Remove and Replace) - Updated firmware install step.
3. Steering Rack (RHD RWD) (1st Generation) (Remove and Replace) - Updated firmware install step.
4. Steering Rack (RHD Dual Motor) (1st Generation) (Remove and Replace) - Updated firmware install step.

Week Ending November 2, 2024

The following new procedure(s) were added:

1. Media Control Unit (Dispose)
2. Windshield Chip Repair (EMEA)

The following procedure(s) were updated:

1. DCDC Converter (Remove and Replace) - Updated removal section to latest validation and revamped installation steps.
2. Media Control Unit (Remove and Replace) - Added disposal instructions to procedure.

Week Ending October 26, 2024

The following new procedure(s) were added:

1. Event Data Recorder Retrieval
2. Module - Autopilot - ECU (Dispose)

The following procedure(s) were updated:

1. Clear Forward Camera View (Precision Cleaning Of Inboard Windshield) - Added a video demonstrating precision cleaning of windshield.
2. Module - Autopilot - ECU - 1st Generation (Remove and Replace) - Added step on Autopilot ECU disposal.
3. Module - Autopilot - ECU - 2nd and 3rd Generation (Remove and Replace) - Added step on Autopilot ECU disposal.
4. Module - Autopilot - ECU - 2nd Generation (RHD) (Remove and Replace) - Added step on Autopilot ECU disposal.