Release Notes October-December 2023

Archived Release Notes:

Week Ending December 30, 2023

The following new procedure(s) were added:
The following procedure(s) were updated:
  1. Module - Autopilot - ECU - 2nd and 3rd Generation (Remove and Replace) - Added note to firmware step.

Week Ending December 23, 2023

The following procedure(s) were updated:
  1. Bushing Carrier - Front Drive Unit (2nd Generation) (Remove and Replace) - Updated brake stiffness routine.
  2. Halfshaft - Front Drive Unit - LH (1st Generation) (Remove and Replace) - Added step to perform test drive to break in new halfshaft(s).
  3. HVAC Assembly - Front (Remove and Replace) - Revised procedure to the latest vehicle validation.
  4. Panel - Cowl Screen (Remove and Replace) - Added instruction for vehicles equipped with pedestrian protection actuators.
  5. Ski - Side Rail - HV Battery - LH (Remove and Replace) - Updated install procedure.

Week Ending December 16, 2023

The following procedure(s) were updated:
  1. Compressor - Air Suspension (Remove and Replace) - Reordered steps to prevent duplicate work.
  2. Door Glass - LH - Front - Adjust - Updated the original nonadjustable correction code to the new adjustable one.
  3. Halfshaft - Front Drive Unit - LH (2nd Generation) (Remove and Replace) - Added step to perform test drive to break in new halfshaft(s).
  4. Half Shafts - Front Drive Unit - LH/RH (2nd Generation) (Remove and Replace) - Added step to perform test drive to break in new halfshaft(s).
  5. Halfshaft - Front Drive Unit - RH (2nd Generation) (Remove and Replace) - Added step to perform test drive to break in new halfshaft(s).
  6. Lights - Fog - Front (Adjust) - Added photo for fog light adjustment.
  7. Ride Height - Adjust - Corrected Toolbox routines for Tesla air suspension.
  8. Seal - Axle - Front Drive Unit - LH (1st Generation) (Remove and Replace) - Removed alignment check.
  9. Seal - Primary - Rear Door - LH (Adjust) - Updated the original nonadjustable correction code to the new adjustable one.
  10. Seat Assembly - 1st Row - LH (Remove and Install) - Added a step of releasing the LH front seat belt retractor.
  11. Motor - Seat Track - 1st Row - LH (Remove and Replace) - Re-write the whole procedure according to the latest validation.

Week Ending December 2, 2023

The following procedure(s) were updated:
  1. Battery Chiller and EXV Assembly (Remove and Replace) - Added a note to differ this procedure from the procedure for vehicles built after April 24, 2019.
  2. Fuse - Pyrotechnic - HV Battery 1.0/1.5 (Remove and Replace) - Updated pyro fuse selection steps.
  3. Fuse - Pyrotechnic - HV Battery 2.0 (Remove and Replace) - Updated pyro fuse selection steps.
  4. Premium Console Sub-assembly (Remove and Replace) - Added steps to remove the wireless charger assembly from the center console sub-assembly.
  5. Seat Assembly - 1st Row - LH (Remove and Replace) - Added step to test the seat ventilation functionality before changing configuration.

Week Ending November 11, 2023

The following new procedure(s) were added:
  1. Inverter - Front Drive Unit (Remove & Replace)
The following procedure(s) were updated:
  1. Door Glass - Rear - Upper - LH (Remove and Replace) - Updated the info about the nuts (x10) that secure the LH falcon door upper class, and added the detailed installation steps.
  2. Liftgate Assembly (Remove and Replace) - Fixed errors.
  3. Sensor - Ultrasonic - Rear Door - LH (Remove and Replace) - Updated ultrasonic sensor temperature for installation.
  4. Seal - Axle - Front Drive Unit - LH (2nd Generation) (Remove and Replace) - Added information about the FDU Oil Seal Installation Auxiliary Rod (2004567-00-A).
  5. Seal - Axle - Front Drive Unit - RH (2nd Generation) (Remove and Replace) - Added information about the FDU Oil Seal Installation Auxiliary Rod (2004567-00-A).
  6. Sensor - Ambient Air Temperature (Remove and Replace) - Added a result image and updated installation steps as per latest validation.

Week Ending October 28, 2023

The following procedure(s) were updated:
  1. TPMS Sensor - ID Learn Procedure - Updated Toolbox routine.

Week Ending October 21, 2023

The following procedure(s) were updated:
  1. Battery - Auxiliary - 12V (Remove and Replace) - Added battery type configuration using the touchscreen.

Week Ending October 14, 2023

The following procedure(s) were updated:
  1. Camera - Triple - Forward Facing (Remove and Replace) - Added a note to remind of checking if the bracket is firmly adhered on the windshield before disassembly to avoid damage.
  2. Disconnect 12V Power - Updated vehicle isolation note.
  3. Taillight Assembly - LH (Remove and Install) - Added a reference to the ECE charge port assembly guidance.

Week Ending October 7, 2023

The following procedure(s) were updated:
  1. Key Fob - Program - Removed Gateway Unlock steps as unneeded.