Model S Service Manual

3305 - Parking Brake

Rear Park Brake Caliper Release
Correction Code 33051005
Park Brake Caliper - Release - Harness Tool - Through Calipers
Correction Code 33051006
Park Brake Caliper - Release - Harness Tool - Through ECU
Correction Code 33051205
Brake Caliper - Rear - Park Brake - LH (Remove and Replace)
Correction Code 33052002
Brake Pads - Park Brake - Set (Remove and Replace)
Correction Code 33052202
Brake Pads - Park Brake - Burnishing
Correction Code 33053000
Module - Electric Park Brake - EPB (Remove and Replace)
Correction Code 33050102
Brake Caliper Pad Slides and Parking Brake Calipers - Cleaning and Lubrication
Correction Code 33013005

Parent topic: 33 - BRAKES

2012-2020 Model S Service Manual
Release Notes
- Current Release Notes
- Release Notes Archive
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
24 - ROOF
- 2410 - Panoramic Roof
- 2430 - Fixed Glass Roof
  - Fixed Glass Roof Rack (Retrofit)
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
  - Steering Wheel (Remove and Replace)
  - Steering Column (Remove and Replace)
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)