23/02/2023 08:13:12

Actuator - Defrost (Remove and Replace)

Correction Code 18102402

Removal

  1. Open the RH front door.
  2. Lower the RH front window.
  3. Remove the glove box. See Glove Box (Remove and Replace).
  4. Disconnect the defrost actuator harness connector, remove the screws (x3) that attach the actuator to the HVAC assembly (torque 1 Nm), and then remove the actuator from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during removal.

Installation

  1. Position the defrost actuator on the vehicle, install the screws (x3) that attach the actuator to the HVAC assembly (torque 1 Nm), and then connect the actuator connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during installation.
  2. Install the glove box. See Glove Box (Remove and Replace).
  3. Raise the RH front window.
  4. Close the RH front door.
  5. Open the LH front door.
  6. Remove the LH instrument panel side cover assembly. See Assembly - Instrument Panel Side Cover - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not remove the antenna from the cover.
  7. Perform a cooling system thermal test. See Cooling System - Thermal Test.
    Informational PurposesAn informational icon, calling your attention
    Note
    Connect Toolbox 3 tethered Ethernet cable to the vehicle antenna connector. Later vehicle builds will connect Toolbox 3 below the MCU.
  8. Install the LH instrument panel side cover assembly. See Assembly - Instrument Panel Side Cover - LH (Remove and Replace).
  9. Close the LH front door.