12/12/2022 10:29:20

Knee Air Bag - Front Passenger's (Remove and Replace)

Correction Code 20010402

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, ensure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.
Informational PurposesAn informational icon, calling your attention
Note
In the event of an airbag or seat belt tensioner deployment, certain airbag and seat belt components must be replaced, and other components must be inspected for damage. Refer to SRS Inspection and Component Replacement for a specific list of items that must be inspected and replaced.

Removal

  1. Open both front doors.
  2. Remove the RH footwell cover (refer to procedure).
  3. Disconnect 12V power. See Disconnect 12V Power .
  4. Remove the nuts (x2) that secure the passenger's knee airbag to the cross beam (torque 10 Nm).
  5. Carefully lower the airbag and disconnect the airbag harness connection.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, eye protection must be worn when performing this operation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Store the airbag module with the deployment side facing up. This will prevent it from being propelled if accidentally deployed, which might cause injury.
  6. Remove the airbag from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

If the component was replaced due to an internal failure:
  1. Connect a laptop with Toolbox 3 to the vehicle.
  2. Unlock the vehicle gateway. See Gateway Unlock.
  3. In Toolbox 3, click Dashboards > Service Tools > DTCs, and then select SDM or RCM depending on the vehicle Restraint Control Type.
  4. Click Read DTCs to display the DTCs.
  5. Power cycle the vehicle.
  6. Click Clear DTCs to clear the DTCs.
  7. Disconnect Toolbox and remove the laptop from the vehicle.