23/05/2022 06:39:24
Tuner - Radio (Remove and Replace)
Correction Code 21220102
Note
This procedure applies to both base and premium tuners (premium pictured).
Removal
- Disconnect the 12V battery (refer to procedure).
- RHD vehicles only: Remove the accelerator pedal (refer to procedure).
- Remove the driver side lower dash trim (refer to procedure).
- Remove the driver side footwell cover (refer to procedure).
- Remove the screws that secure the OBD connector to the amplifier/tuner bracket (torque 4 Nm).
- Release the OBD connector from the cross car beam and set aside.
-
Remove bolts (x3) that attach the
retaining bracket to the cross car beam (torque 6 Nm).
- Carefully lower the bracket into the footwell, to improve access to the tuner.
- Disconnect the 3 wiring harness connectors.
-
Remove screws (x4) that attach
the radio tuner to the bracket (torque 1 Nm).
-
Release the radio tuner from the
bracket.
Installation
Installation procedure is the reverse of removal, except for the following:
- Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update.