02/03/2020 13:50:14

Casing - Key Fob (Remove and Replace)

Correction Code 17450802

CAUTION

Perform this procedure while using the proper anti-electrostatic discharge equipment. Refer to TN-14-92-003, "Electrostatic Discharge Tooling".

Special tool required for this procedure:


Supplier	Part Number	Description
	1086799-00-A	MS key fob tool

Removal

Remove the transmitter battery.
Release the side panel:
- If using a flat screwdriver: Hold the transmitter in one hand. Place the blade of a flat screwdriver or similar object on the edge of the side panel, and then press away from the transmitter to release the side panel. Repeat this step on the other side.
- If using the special tool: Put the rounded side of the tool inside the battery compartment. Turn the tool to the left and to the right to remove the side panel.
Release the 4 clips, then remove the bottom panel.
Remove and retain the circuit board.

CAUTION
Take care not to damage component(s).
Discard the other components.

Place the internal structure in the top panel.
Place the 3 buttons in the internal structure.

Note
Place the shortest button in the front hole, the tallest button in the middle hole, and the medium-length button in the rear hole.

Note
If a button does not sit flush with the internal structure, it is in the wrong position.
Insert the circuit board with the buttons facing down.

CAUTION
Take care not to damage component(s).
Install the bottom cover.
Install the side covers.

Note
Position the tabs on the side cover in the notches at the top of the transmitter, then rotate the side cover into position.
Install the battery.