25/03/2024 17:23:26
Handle - Exterior Release - Door (Recalibrate)
Correction Code 11451300
- 2023-10-23: Updated instructions for calibration using UI.
Recalibrate Using UI
-
Check the vehicle software to make sure that it is 2023.12 or above. If the
vehicle is not 2023.12 or above, update the vehicle software.
NoteThe vehicle software must be 2023.12 or above in order to run door handle calibration on the UI.
- Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock.
- On the vehicle touchscreen, in Service Mode, touch Door Handles, or touch Closures > Door Handles (depending on hardware platform).
- Touch the Calibrate button next to the door to be calibrated.
- Touch Run, and allow the routine to complete.
- Verify the operation of the door handles.
Recalibrate Using Toolbox
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
- Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock.
- In Toolbox 3, click the Actions tab, and then type "Door handle calibration" into the search field.
-
Click on the appropriate link:
- Front LH - Click PROC_DHFD_FRONT-DRV_DOOR-HANDLE-CALIBRATIONvia Toolbox: (link)
- Front RH - Click PROC_DHFP_FRONT-PAS_DOOR-HANDLE-CALIBRATIONvia Toolbox: (link)
- Rear LH - Click PROC_DHRD_REAR-DRV_DOOR-HANDLE-CALIBRATIONvia Toolbox: (link)
- Rear RH - Click PROC_DHRP_REAR-PAS_DOOR-HANDLE-CALIBRATIONvia Toolbox: (link)
- Click Run, and allow the routine to complete.
- Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).
- Verify the operation of the door handles.