02/03/2020 13:50:14

Sensor - Motor - Speed (Remove and Replace)

Correction Code 40102002

Removal

  1. Remove the mid aero shield (refer to procedure).
  2. Disconnect the speed sensor connector.
  3. Remove the bolt that secures the speed sensor to the end bell (torque 8 Nm).
  4. Remove the speed sensor from the end bell.
    Informational PurposesAn informational icon, calling your attention
    Note
    Inspect the O-ring seal for damage and replace if necessary.

Installation

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Only use cleaning agents and solvents in a well-ventilated area.
Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
  1. Apply silicone O-ring lubricant to the O-ring before installation.