20/01/2023 15:25:11
Wheels - Vehicle - Set (Remove and Install)
Correction Code 34012501
Warning
"Jack mode" must be activated on vehicles with air suspension before lifting the vehicle. Failure to do this might lead to suspension damage and could cause serious personal injury.
Note
Vehicles with air suspension might need the suspension to be set to "High" or "Very High" to allow the vehicle to be positioned and supported correctly on a vehicle lift.
Removal
- Position the vehicle on a lift but do not lift it at this time.
-
If equipped, remove the lug nut covers.
Tip: Twin Turbine style wheels: Use a zip tie to help remove the lug nut covers.
-
Initially loosen all lug nuts (x20) (torque 175 Nm).
CAUTIONDo not use an impact wrench to loosen tall lug nuts.
1 Short lug nut 2 Tall lug nut -
Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift.
WarningDo not work on an incorrectly supported vehicle.WarningTo avoid personal injury, use appropriate equipment when performing this operation.
- For each wheel, remove the lug nuts (x5) and then remove the wheel.
Installation
Installation procedure is the reverse of removal, except for the following:
CAUTION
Tighten the lug nuts evenly using a diagonal sequence.
CAUTION
An impact wrench or electric wrench can be used only during the initial threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts.
CAUTION
Use a 6 point socket
to tighten tall lug nuts. Do not use a 12 point socket or a specialty socket on tall
lug nuts.
Note
Inform the customer that a short calibration drive cycle may be required to reset the TPMS.
Note
If wheels of a different diameter are
installed:
- Baolong TPMS: Use Toolbox 3 to change the vehicle configuration. See Gateway Configuration (Display and Change). Then reset the TPMS thresholds (refer to procedure).
- Continental TPMS: Use Toolbox 3 to change the vehicle configuration. See Gateway Configuration (Display and Change).