02/03/2020 13:50:14

Cup Holder (Remove and Replace)

Correction Code 15191802

Removal

  1. Remove the center console assembly (refer to procedure).
  2. Position the center console on a suitable clean bench to prevent damage.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  3. Release the clips (x4) that secure the cup holder front trim. Disconnect the temperature sensor and remove the cup holder front trim.
  4. Remove the rear vent (refer to procedure).
  5. Remove cup holder mat to access screws.
    Tip: Place a cloth over the cup holder mat and release it from the center console using needle nose pliers.
  6. Carefully lift vertically to release both armrests.
  7. Carefully lift vertically to release clips (x7) securing arm rest and cup holder trim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace any broken clips.
  8. Remove screws (x10) securing cup holder assembly to chassis from the top (torque 2 Nm).
  9. Remove clips for air ducting to allow more movement for access.
  10. Remove screws (x4) securing air ducting framework to center console chassis (torque 2 Nm).
  11. Remove screws (x2) securing cup holder to framework (torque 2 Nm).
  12. Remove cup holder assembly.

Installation

  1. Installation procedure is the reverse of removal.