02/03/2020 13:50:14

Base - Armrest - Center Console (Remove and Replace)

Correction Code 15191702

Removal

  1. Release the clips (x4) that secure the center console front trim. Disconnect the temperature sensor and remove the cup holder front trim.
  2. Remove the center console vent (refer to procedure).
  3. On the LH and RH sides of the center console, release the top clips (x3) that secure the rear wrapped center console panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  4. On each side of the center console, remove the screws (x3) that secure the armrest base to the center console carrier (torque 2.5 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  5. Remove the rubber cup holder insert.
    Tip: Place a cloth over the cup holder mat and release it from the center console using needle nose pliers.
  6. Remove the screws (x2) inside the cup holder (torque 2.5 Nm).
  7. Remove the armrest base and set it on a padded surface.

Installation

Installation procedure is the reverse of removal.