12/07/2024 03:22:18

Assembly - Switches/Harness - Steering Wheel (Remove and Replace)

Correction Code 17300512

Installation

  1. Disconnect the LH side switch from the harness, and then install the LH switch to the driver's airbag module. See Switches - Steering Wheel (Remove and Replace).
  2. Fit a cable tie to the driver's air bag module and loosely install it over the switch harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the cable tie as indicated. Do not tighten the cable tie until a later step.
  3. Disconnect the RH side switch from the harness, and then install the RH switch to the driver's airbag module. See Switches - Steering Wheel (Remove and Replace).
  4. Confirm the correct routing of the harness along the driver's airbag module, and then tighten the cable tie.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cut off any excess length of the cable tie.
  5. Install the driver's airbag. See Air Bag - Driver's (Remove and Replace).