02/03/2020 13:50:14

Panel - Door Trim - Rear - LH (Remove and Install)

Correction Code 15132001

Removal

  1. Position the vehicle so that there is full access to the door.
  2. Open the door for access.
  3. Release the screw cover from the door trim panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  4. Remove the screws that secure the trim pad to the door. Note that two screws are concealed by the door handle cover (torque 3 Nm) and one screw is concealed by the pull cup's rubber insert (torque 6 Nm).
  5. Use a trim tool to remove the heart flex clips that secure the trim. Discard the clips.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  6. Support the door trim and disconnect the puddle light connector.
  7. Disconnect the door switch harness connector.
  8. Disconnect the door pocket light harness connector.
  9. Disconnect the harness connector from the rear safety light.
  10. Disconnect the latch release switch connector from the inner door handle.
  11. Remove the door trim from vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

  • Replace plastic heart flex clips after each use.
  • Reuse metal clips unless they are damaged.