08/12/2022 03:42:27
Sensor - Ride Height - Rear - LH (Remove and Replace)
Correction Code 31103002
Warning
If the vehicle has air
suspension, activate "Jack" mode on the touchscreen before raising and
supporting the vehicle.
Removal
- Remove the LH wheel. See Wheel Assembly (Remove and Install).
- Disconnect the ride height sensor connector and harness.
-
Remove the nut that secures the link to the upper suspension link (torque 7
Nm).
CAUTIONTo prevent ball joint damage, always hold the ball joint pin with a wrench while loosening or tightening the lock nut.
-
Remove the bolt that secures the ride height sensor to the body (torque 7
Nm).
- Remove the ride height sensor from the vehicle.
Installation
Installation procedure is the reverse of removal, except for the following:
Note
Clean the affected areas before
installation.
CAUTION
Replace all nylon-insert
locknuts.
- Calibrate the ride height sensors. See Ride Height - Adjust.