25/10/2023 05:36:04
Module - Door Handle Controller - Front - LH - Generation 3.0 (Remove and Replace)
Correction Code 11451122
- 2023-10-25: Rearranged installation steps.
Special tool required for this procedure:
Supplier | Part Number | Description |
Tesla | 1069651-00-D | ASSEMBLY, DOOR HANDLE 3.0 CTLR |
Removal
- Remove the door trim panel (refer to procedure).
- Remove one side of the felt tape then remove the old clips (x9) from LH front door panel.
-
Release the screw (x1) that attaches the top of the door handle controller module to the closeout panel (torque 2 Nm).
-
Remove the door handle controller module from the retainer tabs on the closeout panel, and then disconnect the door handle controller module wiring harness.
Installation
- Install new clips (x9) to the LH front door panel.
- Perform the door handle 3.0 calibration procedure. See Handle - Exterior Release - Door (Recalibrate).
- Perform a firmware reinstall. See Firmware Reinstall - Touchscreen.
- Verify the operation of all door handles.