28/03/2023 15:18:28

Actuator - Inlet (Remove and Replace)

Correction Code 18102002

  • 2023-03-28: Updated procedure to revised validation.

Removal

  1. Open the RH front door.
  2. Lower the RH front window.
  3. Remove the glove box. See Glove Box (Remove and Replace).
  4. Disconnect the inlet actuator harness connector, remove the screws (x3) that attach the actuator to the HVAC assembly, and then remove the actuator from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during removal.

Installation

  1. Position the inlet actuator on the vehicle, install the screws (x3) that attach the actuator to the HVAC assembly, and then connect the actuator connector.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of the actuator position during installation.
  2. Install the glove box. See Glove Box (Remove and Replace).
  3. Perform a cooling system thermal test. See Cooling System - Thermal Test.
    Informational PurposesAn informational icon, calling your attention
    Note
    The thermal test will confirm functionality and clear any alerts / DTCs.
  4. Raise the RH front window.
  5. Close the RH front door.