05/07/2022 05:03:03

Sensor - Brake Reservoir Fluid Level (Remove and Replace)

Correction code 33200012

Remove

  1. Open the LH front door and lower the window.
  2. Remove the HEPA filter inlet duct. See Duct - HEPA Filter - Inlet (Remove and Replace).
  3. Remove the push clips (x4) that attach the LH shock tower cover to the body, and then remove the LH shock tower cover.
  4. Remove the clip that attaches the left side of the cowl panel to the body, and then raise the left side of the cowl panel.
  5. Release the tabs that attach the brake fluid level sensor to the brake fluid reservoir.
  6. Remove the brake fluid level sensor from the brake fluid reservoir.
  7. Disconnect the brake fluid reservoir level sensor connector, and then remove the sensor from the vehicle.

Install

Installation procedure is the reverse of removal.