20/01/2023 13:05:42

TXV Valve - Chiller (Remove and Replace)

Correction Code 18205102

Removal

  1. Recover refrigerant from the vehicle (refer to procedure).
  2. Disconnect 12V power. See Disconnect 12V Power .
  3. Remove the front skid plate (refer to procedure).
  4. Remove the nut that secures the pipe retaining plate to the TXV (torque 12 Nm).
  5. Disconnect the refrigerant pipes from the TXV.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Remove and discard O-rings.
  6. Disconnect the TXV solenoid valve connector.
  7. Remove the bolts (x2) that secure the TXV to the battery chiller (torque 6 Nm).
  8. Remove the TXV from the battery chiller.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
  2. Replace the A/C pipe and chiller O-rings.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Lubricate new O-rings with clean refrigerant oil.
  3. Replace the battery chiller O-rings.
  4. If the new TXV does not have a solenoid, install a coolant valve dummy plug on the vehicle-side electrical harness connector.
  5. Recharge the refrigerant. See A/C Refrigerant Recovery and Recharge (Remove and Replace).
  6. Perform a cooling system thermal test. See Cooling System - Thermal Test.