29/04/2022 09:34:32
Sensor - Parking Distance - Outer - Rear (Remove and Replace)
Correction Code
17271122
Note
This procedure applies to rear parking
sensors 7 and 12. The replacement of sensor 12 is described in the procedure
below.
Removal
- Open the LH front door and lower the LH front window.
- Set the air suspension to the Very High, and then turn on Jack Mode.
-
Remove the screw that attaches the rear fascia to the LH rear quarter panel
(torque 1.5 Nm).
-
Apply masking tape to the edge of the LH rear quarter panel that is adjacent to
the rear fascia.
-
Carefully pull the LH end of the rear fascia away from the vehicle so that the
outer parking distance sensor can be accessed.
-
Release the locking tab, and then disconnect the electrical harness from the
parking distance sensor.
-
Carefully release the tabs that attach the parking sensor to the fascia bracket,
and then remove the sensor from the bracket.
Tip: If needed, use a pick or small flat head screwdriver to carefully release the bracket tabs.NoteMake sure the sensor retainer ring is also removed.
-
If reusing the retainer ring, remove the retainer ring and inspect for
damage.
CAUTIONDo not reuse the ring if it is overly worn or damaged.
Installation
-
Installation procedure is the reverse of removal, except for the following:
CAUTIONMake sure a retainer ring is installed on the new parking sensor.CAUTIONMake sure the fascia sensor bracket tabs are securely holding the sensor. If necessary, carefully bend the tabs inward so that the sensor is securely held in place.NotePerform a push-pull-push test on the electrical harness to verify proper connection.NoteMake sure the sensor retainer ring is fully seated against the fascia.
