31/05/2024 09:44:53

Hose - Front HVAC - Drain (Dual Motor) (Remove and Replace)

Correction Code 18103802

Remove

  1. Perform Vehicle HV Disablement Procedure. See Vehicle HV Disablement Procedure
  2. Remove the RH steering brace:
    1. Remove the bolt that secures the steering brace to the subframe (torque 26 Nm).
    2. On the RH side of the vehicle, release the fir tree clip that secures the coolant hose to the steering brace.
    3. On the RH side of the vehicle, loosen the bolt that secures the steering brace to the base of the side rail (torque 26 Nm), then remove the brace.
      Informational PurposesAn informational icon, calling your attention
      Note
      Do not remove the bolt.
    4. Informational PurposesAn informational icon, calling your attention
      Note
      This step is for air suspension vehicles only.
      On the LH side of the vehicle, release the clip that secures the air suspension line to the steering brace.
  3. Release the 2 bolts that secure each fuse box to the front crossmember (torque 5 Nm). Move both fuse boxes behind the front crossmember.
  4. Release the fasteners that secure the air suspension reservoir (torque 2.5 Nm), then set the reservoir aside.
  5. Release the 2 harnesses on the RH side of the DCDC converter.
  6. Remove the RH closeout panel (refer to procedure).
  7. Place a rag underneath the hose to catch any water that is spilled in a later step.
  8. Spray silicone onto the drain hose to ease removal.
  9. Working inside the vehicle, gently twist and pull on the hose to release it from the HVAC unit.
  10. Working in the underhood area, spray silicone onto the hose near the grommet.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not spray silicone into one of the exposed DCDC harness connectors.
  11. Pull the hose through the grommet and remove it from the vehicle.

Installation

  1. Spray silicone lubricant onto the grommet and the tip on the straight end of the hose.
  2. Fold the straight end of the hose into a U-shape and slide it into the grommet from the underhood area. Push the hose through the grommet into the vehicle.
  3. Working inside the vehicle, secure the hose onto the HVAC unit.
  4. Reinstall all components that were removed for access.