02/03/2020 13:50:14

Door Assembly - Front - LH (Remove and Install)

Correction Code 10106001

Removal

  1. Position the vehicle with clear access to the door assembly.
  2. Remove the sill panel trim (refer to procedure)
  3. Disconnect the door harness connectors (x3) from the dash wiring harness.
  4. Support the door on a stand.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  5. Mark installed positions of hinge to 'A' post to aid installation.
  6. Remove the bolts (x6) that secures the door hinges to body (torque 31 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Components have been removed in this graphic to aid clarity.
  7. With assistance, release the harness grommet from the 'A' post.
  8. Carefully withdraw the door wiring harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  9. Remove door and position aside to prevent damage.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Protect exterior paint surfaces during this procedure.

Installation

  1. Installation procedure is the reverse of removal, except for the following:
  2. Install door and set hinges to witness marks. Check door alignment, adjust if required.