02/03/2020 13:50:14

IP Carrier (Remove and Replace)

Correction Code 14052102

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, ensure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.

Removal

  1. Position the vehicle so that both front doors can be fully opened.
  2. Move the driver's seat fully rearwards.
  3. Move the passenger's seat fully rearwards.
  4. Move the steering column to the lowest position, and fully extended.
  5. Open the glove box.
  6. Disconnect 12V power. See Disconnect 12V Power .
  7. Remove the defrost mesh grille assembly (refer to procedure).
  8. Remove the touchscreen (refer to procedure).
  9. Remove the glove box assembly (refer to procedure).
  10. Make sure that the front wheels are in the straight ahead position.
  11. Working from the driver's footwell, remove the bolts that attach the steering column to the IP carrier bracket:
    • Vehicles built before April 11, 2016: upper and lower fasteners - torque 30 Nm
    • Vehicles built on or after April 11, 2016:
      • Upper fasteners - torque 30 Nm
      • Lower fasteners - torque 17 Nm
  12. Remove the screws (x15) that attach the IP carrier to the dash frame (torque 2 Nm).
  13. Remove the IP carrier from the dash frame.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolt(s).

Transfer the speakers to the new IP carrier.