Model S Service Manual

5002 - Wall Connector

Handle and Cable Assembly - 40A Wall Connector (Remove and Replace)
Correction Code 50024002
Handle and Cable Assembly - 80A Wall Connector (Remove and Replace)
Correction Code 50022002
200A Fuses - Wall Connector (Remove and Replace)
Correction Code 50020102
Remove Stuck Deadfront - Charge Handle
Correction Code 50010202

Parent topic: 50 - EXTERNAL CHARGING CONNECTORS

2012-2020 Model S Service Manual
Release Notes
- Current Release Notes
- Release Notes Archive
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
24 - ROOF
- 2410 - Panoramic Roof
- 2430 - Fixed Glass Roof
  - Fixed Glass Roof Rack (Retrofit)
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
  - Steering Wheel (Remove and Replace)
  - Steering Column (Remove and Replace)
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)