16/02/2024 14:13:20
Wheel Assembly (Remove and Install)
Correction Code 34015001
- 2023-06-08: Added tightening torque to installation section.
Warning
If the vehicle has air
suspension, activate "Jack" mode on the touchscreen before raising and
supporting the vehicle.
Note
Vehicles with air suspension might need the suspension
to be set to "High" or "Very High" to allow the vehicle to be positioned and
supported correctly on a vehicle lift.
Removal
- Position the vehicle on a lift but do not lift it at this time.
-
If equipped, remove the lug nut covers.
Tip: Twin Turbine style wheels: Use a zip tie to help remove the lug nut covers.
-
Initially loosen the lug nuts (x5) (torque 175 Nm).
CAUTIONDo not use an impact wrench to loosen tall lug nuts.
1 Short lug nut 2 Tall lug nut -
Raise and support the vehicle (refer to procedure).
WarningDo not work on an incorrectly supported vehicle.WarningTo avoid personal injury, use appropriate equipment when performing this operation.
- Remove the lug nuts (x5) and then remove the wheel.
Installation
Installation procedure is the reverse of removal, except for the following:
CAUTION
Tighten the lug nuts evenly using a diagonal
sequence.
CAUTION
An impact wrench
or electric wrench can be used only during the initial threading of the lug
nuts. Use a torque wrench to fully tighten the lug nuts to 175 Nm.
CAUTION
Use a 6 point
socket to tighten tall lug nuts. Do not use a 12 point socket or a specialty
socket on tall lug nuts.
Note
Any time the TPMS sensors are not reinstalled in
the same locations (for example, when rotating the tires), perform the TPMS
sensor ID learn procedure:
- Baolong TPMS: (refer to procedure).
- Continental TPMS: (refer to procedure).
Note
If wheels of a different diameter are
installed:
- Baolong TPMS: Use Toolbox 3 to change the vehicle configuration. See Gateway Configuration (Display and Change). Then reset the TPMS thresholds (refer to procedure).
- Continental TPMS: Use Toolbox 3 to change the vehicle configuration. See Gateway Configuration (Display and Change).