2022-09-16

Stabilizer Bar - Front (Dual Motor) (3rd Generation) (Remove and Replace)

Correction Code 31012212

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Always activate "Jack Mode" on the touchscreen before raising and supporting the vehicle equipped with air suspension.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, ensure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.

Installation

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolts and nyloc nuts.
  1. Position the stabilizer bar correctly on the subframe.
  2. Install the front subframe. SeeSubframe Assembly - Front (3rd Generation) (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Before installing the mid aero shield panel: Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.