Model S Service Manual

3110 - Air Suspension System

Adaptive Air Spring Module - Front - LH (Remove and Replace)
Correction Code 31105012
Air Dryer - Tesla Air Suspension (Regenerate)
Correction Code 31101008
Air Line - Air Suspension - Compressor to Valve Block (Remove and Replace)
Correction Code 31104502
Air Line - Air Suspension - Reservoir to Compressor (Remove and Replace)
Correction Code 31104302
Air Line - Air Suspension - Valve Block Exhaust (Remove and Replace)
Correction Code 31104702
Air Line - Air Suspension - Valve Block to LH Front Air Spring (Remove and Replace)
Correction Code 31104002
Air Spring Module - Front - LH (Remove and Replace)
Correction Code 31105002
Air Spring Module - Rear - LH (Remove and Replace)
Correction Code 31106002
Air Suspension - Pressurize/Depressurize - One Air Spring
Correction Code 31101200
Air Suspension - Pressurize/Depressurize - Full System
Correction Code 31101500
Air Suspension - Primary Lines Assembly (Remove and Replace)
Correction Code 31104102
Compressor - Air Suspension (Remove and Replace)
Correction Code 31102002 Correction Code 31102302
Harness - Adaptive Air Spring Module - Front - LH (Remove and Replace)
Correction Code 31100012
Reservoir - Air Suspension (Remove and Replace)
Correction Code 31102502
Line - Air Suspension (Repair)
Correction Code 31104808
Module - Air Suspension - ECU (Remove and Install)
Correction Code 31100101
Module - Air Suspension - ECU (Remove and Replace)
Correction Code 31100102
Module - Air Suspension - ECU (Tesla) (LHD) (Remove and Replace)
Correction code 31100112
Module - Air Suspension - ECU (RHD) (Remove and Install)
Correction Code 31100201
Module - Air Suspension - ECU (Continental) (RHD) (Remove & Replace)
Correction Code 31100202
Module - Air Suspension - ECU (Tesla) (RHD) (Remove and Replace)
Correction Code 31100212
Sensor - Ambient Air Temperature - Compressor (Remove and Replace)
Correction Code 31102102
Sensor - Ride Height - Front - LH (Remove and Replace)
Correction Code 31102802
Sensor - Ride Height - Front - LH (Retrofit)
Correction code 31102806
Sensor - Ride Height - Rear - LH (Remove and Replace)
Correction Code 31103002
Valve Block - Air Suspension (Remove and Replace)
Correction Code 31102202

Parent topic: 31 - SUSPENSION

2012-2020 Model S Service Manual
Release Notes
- Current Release Notes
- Release Notes Archive
GENERAL INFORMATION
00 - INSPECTION AND SERVICE
10 - BODY
11 - CLOSURE COMPONENTS
12 - EXTERIOR FITTINGS
13 - SEATS
14 - INSTRUMENT PANELS AND PEDALS
- 1405 - Instrument Panel
15 - INTERIOR TRIM
16 - BATTERY SYSTEM
17 - ELECTRICAL
18 - THERMAL MANAGEMENT
20 - SAFETY AND RESTRAINT
21 - INFOTAINMENT
24 - ROOF
- 2410 - Panoramic Roof
- 2430 - Fixed Glass Roof
  - Fixed Glass Roof Rack (Retrofit)
30 - CHASSIS
- 3001 - Chassis and Subframes
31 - SUSPENSION
32 - STEERING
- 3201 - Steering Rack and Lower Column
- 3205 - Upper Column, Steering Wheel
  - Steering Wheel (Remove and Replace)
  - Steering Column (Remove and Replace)
33 - BRAKES
34 - WHEELS AND TIRES
39 - FRONT DRIVE UNIT
40 - REAR DRIVE UNIT
44 - HIGH VOLTAGE SYSTEM
50 - EXTERNAL CHARGING CONNECTORS

© Tesla 2024
Procedure Feedback
Site Feedback

Crowsfoot or Offset Wrench Extension Calculator

Torque Calculator Values

T1 (Original torque spec)

L (Distance from center of wrench grip to center of square drive tang)

E (Horizontal distance from center of square drive tang to center of fastener)

Note

If the angle from the extension to the torque wrench is greater than 90° (Figure 2), input E as a positive number.
If the angle from the extension to the torque wrench is less than 90° (Figure 3), input E as a negative number.
If the angle from the extension to the torque wrench is exactly 90°, this calculator is not needed. Torque the fastener to T1.

T2 (Final torque setting)