20/01/2023 14:32:46

Wheels - Axle Set (Remove and Install)

Correction Code 34012401

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
"Jack mode" must be activated on vehicles with air suspension before lifting the vehicle. Failure to do this might lead to suspension damage and could cause serious personal injury.
Informational PurposesAn informational icon, calling your attention
Note
Vehicles with air suspension might need the suspension to be set to "High" or "Very High" to allow the vehicle to be positioned and supported correctly on a vehicle lift.

Removal

  1. Position the vehicle on a lift but do not lift it at this time.
  2. If equipped, remove the lug nut covers.
    Tip: Twin Turbine style wheels: Use a zip tie to help remove the lug nut covers.
    Figure 1. Position the extruded end of the zip tie away from the wheel spoke
  3. On both sides of the vehicle, initially loosen the lug nuts (x10) (torque 175 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not use an impact wrench to loosen tall lug nuts.
    1 Short lug nut
    2 Tall lug nut
  4. Raise and support the vehicle (refer to procedure).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Do not work on an incorrectly supported vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, use appropriate equipment when performing this operation.
  5. On both sides of the vehicle, remove the lug nuts (x5) and then remove the wheel.

Installation

Installation

Installation procedure is the reverse of removal, except for the following:
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Tighten the lug nuts evenly using a diagonal sequence.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
An impact wrench or electric wrench can be used only during the initial threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Use a 6 point socket to tighten tall lug nuts. Do not use a 12 point socket or a specialty socket on tall lug nuts.
Informational PurposesAn informational icon, calling your attention
Note
Any time the TPMS sensors are not reinstalled in the same locations (for example, when rotating the tires), perform the TPMS sensor ID learn procedure:
Informational PurposesAn informational icon, calling your attention
Note
If wheels of a different diameter are installed: