29/11/2023 23:55:57

Premium Console Sub-assembly (Remove and Replace)

Correction Code 15197002

  • 2023-11-30: Added steps to remove the wireless charger assembly from the center console sub-assembly.

Removal

  1. Open all four doors and lower all four windows.
  2. Move the front seats backward.
  3. Remove the cubby tray below the touchscreen.
  4. On both sides of the premium center console sub-assembly, carefully release the clips that secure the side trim panel.
  5. Carefully release the clips that secure the front trim panel to the center console.
  6. Disconnect the electrical harness from the cabin temperature sensor connector, and then remove the front console panel.
  7. Apply masking tape to the front of the cup holder trim to avoid damage during removal.
  8. Remove the premium console dividers (x4) and the front mat from the console sub-assembly.
  9. Open the center console phone dock door, and then disconnect the wireless charger USB electrical connector and release the cable from the clips.
  10. Remove the bolts that secure the middle of the console to body (torque 3 Nm).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 in extension
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  11. Remove the screws that secure the console sub-assembly to the center console carrier (torque 2.5 Nm).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 3 in extension
    • T20 socket
    • Flex head ratchet/flex head torque wrench
  12. Remove the premium center console sub-assembly from the vehicle.
  13. Remove the phone dock mat from the premium center console sub-assembly.
  14. Remove the screws that attach the phone dock adapter to the vehicle, and then remove the phone dock adapter from the vehicle (torque 0.28 Nm).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • PH1 Phillips Screwdriver
  15. Lift up on the sides of the wireless charger assembly, and then release it from the dock door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tilt the dock door as required.
  16. Remove the sliding lid from the center console sub-assembly by sliding it towards the rear of the sub-assembly and lifting up once the clips are released from the holes in the sub-assembly.

Installation

Installation procedure is the reverse of removal, except for the following:
Informational PurposesAn informational icon, calling your attention
Note
Remove the masking tape from the front of the cup holder trim.