16/12/2022 06:14:54

Siren - Battery Backed (Remove and Replace)

Correction Code 17451002

Removal

  1. Remove the underhood storage unit:
  2. Disconnect the harness from battery coolant pump 2.
    Informational PurposesAn informational icon, calling your attention
    Note
    Battery coolant pump 2 is on the LH side of the vehicle.
  3. Slide the coolant pump and rubber isolator off of the bracket and set them aside.
  4. Remove the nut that secures the siren (torque 7 Nm).
  5. Maneuver the siren up past the coolant pump bracket, but do not completely remove the siren from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    At this point in the procedure, the siren harness is still connected.
  6. Disconnect the electrical connector from the siren.
  7. Remove the siren from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:
  1. Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect).
  2. Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock.
  3. Using Toolbox 3:
    1. Select the Actions tab and search for "Pektron Learn Car".
    2. Select the ODIN routine PROC_BDY_X_PEKTRON-LEARN-CARvia Toolbox: (link), and then click the link of the routine.
    3. Click RUN, and allow the routine to complete.
  4. Disconnect the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).