08/12/2022 10:27:17

Curtain Air Bag - Driver's (Remove and Replace)

Correction Code 20010502

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.
Informational PurposesAn informational icon, calling your attention
Note
Before disconnecting the 12V power supply, ensure that the driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.
Informational PurposesAn informational icon, calling your attention
Note
In the event of an airbag or seat belt tensioner deployment, certain airbag and seat belt components must be replaced, and other components must be inspected for damage. Refer to SRS Inspection and Component Replacement for a specific list of items that must be inspected and replaced.

Removal

  1. Disconnect 12V power. See Disconnect 12V Power .
  2. Lower the headlining trim for access (refer to procedure).
  3. Disconnect the curtain airbag harness connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, observe all relevant safety precautions before removing or testing any SRS components.
  4. Remove the screws (x9) that secure the curtain airbag to the body (torque 10 Nm).
  5. Remove the clip that secures the pyrotechnic to the cantrail.
  6. Release the airbag location pegs (x5) from the cantrail.
  7. Remove the curtain airbag assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Store the airbag module with the deployment side facing up. This will prevent it from being propelled if accidentally deployed, which might cause injury.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolt(s).
If the component was replaced due to an internal failure:
  1. Connect a laptop with Toolbox 3 to the vehicle.
  2. Unlock the vehicle gateway. See Gateway Unlock.
  3. In Toolbox 3, click Dashboards > Service Tools > DTCs, and then select SDM or RCM depending on the vehicle Restraint Control Type.
  4. Click Read DTCs to display the DTCs.
  5. Power cycle the vehicle.
  6. Click Clear DTCs to clear the DTCs.
  7. Disconnect Toolbox and remove the laptop from the vehicle.