12/04/2022 06:35:50
HV Harness - Rear Drive Unit to HVJB (Subframe Removed) (Remove & Replace)
Correction code 44501702
Remove
- Lower the vehicle to a comfortable working height (refer to procedure).
- Connect the12V battery negative terminal.
- Open all four doors.
- Move both front seats fully forward.
- Disconnect the 12V negative terminal.
-
Remove the 2nd row seat frame:
- Standard seats: refer to procedure .
- Executive seats: refer to procedure .
-
Remove the HVIL bolt from the HVJB
cover. Do not remove the remaining fasteners at this time.
-
North America, Japan (torque 4
Nm)NoteIn North American and Japanese vehicles, the HVIL bolt is one-time use only. Install a new bolt during reinstallation.
-
Europe, APAC (torque 5 Nm)NoteIn European and APAC vehicles, the HVIL bolt can be reused during reinstallation.
-
North America, Japan (torque 4
Nm)
-
Remove the remaining fasteners that
secure the HVJB cover.
-
North America, Japan (torque 8
Nm)NoteIn North American and Japanese vehicles, there are 5 additional fasteners.
-
Europe, APAC (torque 8 Nm)NoteIn European and APAC vehicles, there are 6 additional fasteners.
-
North America, Japan (torque 8
Nm)
-
Remove the nuts (x2) that attach rear
drive inverter and HV battery cables to the HVJB (torque 9 Nm).
- Release the grommet at the body channel, and then remove the RDU HV cable harness from HVJB through the body channel.