02/03/2020 13:50:14

12V Positive Jump Post (Remove and Replace)

Correction Code 17013102

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Before disconnecting the 12 volt power supply, ensure that driver’s door window is fully open. Failure to follow this instruction could result in vehicle lockout.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the 12 volt power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shatter.

Removal

  1. If the vehicle has a 1st generation front fascia applique (nosecone), remove the front underhood apron (refer to procedure). If the vehicle has a 2nd generation front fascia applique (nosecone), remove the applique (refer to procedure).
  2. Disconnect 12V power. See Disconnect 12V Power .
  3. Check for voltage at the jump post. Ensure the voltage is 0V.
  4. Release the nut that secures the electrical harness to the jump post (torque 6 Nm).
  5. Release the nuts (x2) that secure the jump post to the bumper (torque 3 Nm).
  6. Remove the jump post from the vehicle.

Installation

  1. Installation procedure is the reverse of removal.