23/01/2023 10:30:14
Premium Boost Amplifier (RHD) (Remove and Replace)
Correction Code 21213512
Removal
- Remove HEPA filter outlet duct. See (refer to procedure).
- Disconnect 12V power. See (refer to procedure).
- Remove the accelerator pedal. See (refer to procedure).
-
Remove the screws (x2) that attach the OBDII connector to the tuner bracket, and then remove the connector from the bracket.
-
Disconnect the electrical harness from the premium amplifier connector.
- Remove steering column. See (refer to procedure).
- Remove brake pedal. See (refer to procedure).
-
Release the clips (x2) that attach the main electrical harness to the bulkhead, and move the harness away from the tuner.
-
Release the edge clip that attaches the front electrical harness to the body, and move the harness away from the tuner.
-
Remove the bolts (x3) that attach the amplifier/tuner bracket assembly to the cross car beam.
-
Disconnect the electrical harness from the tuner connectors.
-
Release the fir tree clip that attaches the electrical harness to the cross car beam, and then move the electrical harness to the side.
-
Move the amplifier/tuner bracket assembly out through the bottom of the IP carrier, and then remove the assembly from the vehicle.
Tip: Rotate the bracket assembly to different angles to ease removal.
-
Remove the screws (x4) that attach the amplifier to the amplifier/tuner bracket, and then remove the amplifier from the bracket.
Installation
-
Install the amplifier onto the amplifier/tuner bracket, and then install the screws (x4) that attach the amplifier to the bracket (torque 4 Nm).
-
Move the amplifier/tuner bracket assembly up through the bottom of the IP carrier.
Tip: TIP Rotate the bracket assembly to different angles to ease installation.
-
Bring the electrical harness to the tuner, and then fasten the fir tree clip that attaches the electrical harness to the cross car beam.
-
Connect the electrical harness to the tuner connectors.
-
Install the bolts (x3) that attach the amplifier/tuner bracket assembly to the cross car beam (torque 6 Nm).
-
Move the front electrical harness to the tuner, and fasten the edge clip that attaches the electrical harness to the body.
-
Move the main electrical harness to the tuner, and fasten the clips (x2) that attach the electrical harness to the bulkhead.
- Install the brake pedal. See (refer to procedure).
- Install the steering column. See (refer to procedure).
-
Connect the electrical harness to the premium amplifier connector.
-
Install the OBDII connector to the tuner bracket, and then install the screws (x2) that attach the connector to the bracket (torque 4 Nm).
- Install the accelerator pedal. See (refer to procedure).
- Connect 12V power. See (refer to procedure).
- Install the HEPA filter outlet duct. See (refer to procedure).
- Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update.