07/12/2022 16:55:24

Seat Assembly - 1st Row - LH (Remove and Install)

Correction Code 13040101

Removal

  1. Note the customer's seating profile.
  2. Position the vehicle to provide good access to the 1st row LH seat.
  3. Power the seat fully rearward for access.
  4. Release the clips (x4) and remove the outer seat track cover.
  5. Remove and discard the bolts (x2) that secure both seat tracks to the floor panel (torque inboard bolt 34 Nm, outboard bolt 17 Nm).
  6. Power the seat fully forward for access.
  7. Remove and discard the bolts (x2) that secure both seat tracks to the floor panel (torque inboard bolt 34 Nm, outboard bolt 17 Nm).
  8. Adjust the position of the seat for easy removal:
    1. Power the seat to the middle of the seat tracks.
    2. Position the seat backing so that it is in the most upright position.
    3. Power the seat fully downward towards the floor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Ensure that the first responder loop has been disconnected for at least 2 minutes.
  9. Disconnect 12V power. See Disconnect 12V Power .
  10. Release the clips that secure the connectors, then disconnect the seat connectors and harnesses (x3).
  11. With assistance, remove the seat from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid damage when moving or rotating the seat, hold the base with one hand and the back with the other. Have an assistant hold the other side in the same manner.

Installation

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all patchbolt(s).
  1. Restore the seating profile.