2020-03-02

Assembly - Back Rest - Driver's Seat (Remove and Replace)

Correction Code 13043002

Removal

  1. Remove driver's seat assembly (refer to procedure)
  2. Place seat on clean work surface.
  3. Remove screw securing outer side cover to seat (torque 1 Nm).
  4. Carefully release outer side cover from retaining bracket and lay it aside with harnesses still connected.
  5. Remove outer side cover assembly.
  6. Remove screw securing inner side cover to seat (torque 1 Nm).
  7. Carefully release inner side cover from retaining bracket.
  8. Release clip securing seat harness to cover.
  9. Remove inner side cover.
  10. Reposition seat.
  11. Disconnect seat back rest heater element connector and harness.
  12. Disconnect seat back lumbar support connector and harness.
  13. Disconnect side airbag connector and harness.
  14. With assistance, remove bolts (x4) securing seat back rest to seat base and remove seat back rest assembly and place aside (torque 32 Nm). NOTE: LH bolts shown.

Installation

  1. Installation procedure is the reverse of removal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Clean the affected areas before installation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Replace all patchbolt(s).