2020-12-23

Bracket - License Plate - Front (Retrofit)

Correction Code 12070106

Special tool(s) required for this procedure:


Part Number	Description
223-28550-TSL	WIHA (TORQUE SCREWDRIVER .1 - .6NM)

This procedure only applies to vehicles built through April 10, 2016.

Procedure

Clean the affected area.
Test fit the license plate bracket on the front fascia applique:
- The middle hole in the license plate bracket is centered below the Tesla logo.
  TIp
  Use tape or similar means of ensuring that the hole is completely centered.
- There is no gap between the base of the front fascia applique and the curved section at the base of the license plate bracket.
  Bracket flush with applique Gap between bracket and applique
Use a paint pen to mark the front fascia applique at the center of the holes (x3) in the license plate bracket. Remove the license plate bracket.
Drill a hole through the front fascia applique in the areas marked in the previous step.
- 1st generation front fascia applique: Use a 19/64 in drill bit.
- 2nd generation front fascia applique: Use a 1/8 in (3.5 mm) drill bit.
Warning
Wear protective eyewear and hearing protection when drilling.

CAUTION
Only drill through the front fascia applique. Drilling too far can result in damage to the vehicle.
Clean the affected area.

Install the front license plate bracket:

1st generation front fascia applique: Secure the license plate bracket with push clips (x3).
2nd generation front fascia applique: Secure the license plate bracket with the self-tapping screws (x3) (torque 0.5 Nm).
CAUTION
Do not overtorque the screws.


1st generation applique:	2nd generation applique: