28/08/2020 11:58:43

Sensor - Radar - Front (Remove and Replace)

Correction Code 17201502 Correction Code 17201602

Choose the appropriate procedure based on the vehicle's date of manufacture:

1st Generation

Correction Code 17201502

Removal

  1. Remove the front fascia (refer to procedure).
  2. Remove the radar sensor gasket.
    Informational PurposesAn informational icon, calling your attention
    Note
    The flaps on each side of the radar sensor gasket are secured to the radar sensor with double-sided tape.
  3. Use a trim tool or flathead screwdriver to gently pry up the tab on the top of the inner bracket, and gently release the radar sensor from the bracket.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The radar sensor is still connected by a harness. Do not attempt to remove the radar from the vehicle at this time.
  4. Disconnect the electrical harness on the bottom of the radar sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    There is little slack in the electrical harness. Do not damage the connector.
  5. Remove the radar sensor.

Installation

  1. Bring the radar sensor to the sensor bracket, and then connect the electrical harness to the bottom of the radar sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    There is little slack in the harness. Do not damage the connector.
  2. Insert the radar sensor into the bottom of the bracket, gently press the sensor into the top of the inner bracket, and then fasten the tab that attaches the sensor to the bracket.
  3. Replace the double-sided tape on the inboard side of the flaps of the radar sensor gasket.
  4. Install the radar sensor gasket, and then press the flaps against the sides of the radar sensor to secure them to the sensor.
  5. Install the front fascia (refer to procedure).
  6. Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update.
  7. Calibrate the front radar sensor (refer to procedure).

2nd Generation

Correction Code 17201602

Removal

  1. Remove the front fascia (refer to procedure).
  2. Release the clip that secures the radar sensor electrical harness to the radar bracket.
  3. Disconnect the electrical connector from the radar sensor.
  4. Release the fasteners that secure the radar bracket to the front bumper (torque 6 Nm), and then remove the radar bracket and radar sensor from the vehicle as an assembly.
  5. Use a trim tool to release the tabs that secure the radar sensor to the radar bracket, and then remove the radar sensor from the bracket.

Installation

  1. Install the radar sensor into the radar bracket, and then fasten the tabs that secure the sensor to the bracket.
  2. Install the radar sensor assembly to the vehicle front bumper, and then install the fasteners that secure the assembly to the bumper (torque 6 Nm).
  3. Connect the electrical harness to the radar sensor connector.
  4. Fasten the clip that secures the radar sensor electrical harness to the radar bracket.
  5. Install the front fascia (refer to procedure).
  6. Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update.
  7. Calibrate the front radar sensor (refer to procedure).