2026-05-13

Wiper Module (Remove and Replace)

Correction Code 17500102

    • 2026-05-13: Added pinch point warning.
  • 2024-12-03: Updated procedure to latest procedure validation.

Removal

  1. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  2. Remove the bolts (x3) that attach the wiper module to the bulkhead.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    6 Nm (4.4 lbs-ft)
  3. Carefully release the wiper module and rotate it to get access to the harness connector.
  4. Disconnect the harness connector from the wiper module.
  5. Remove the wiper module from the vehicle.

Installation

Installation procedure is the reverse of removal.