02/03/2020 13:50:14
Position Sensor - Door - Exterior Handle - Front - LH (Remove and Replace)
Correction Code 11456502
Removal
- Remove the door handle assembly (refer to procedure).
- Remove and discard the door handle rear seal.
- Remove the control link pivot pin to allow the control link to be released from the housing.
- Position the control link and remove the screw that secures the position sensor to the link (torque 1 Nm).
-
Remove the screw that secures the position sensor to the housing (torque 1.5
Nm).
- Release the wiring harness and remove the position sensors (x2).
- Remove the screw that secures the position sensor to the bracket (torque 1 Nm).
- Remove the bracket.
Installation
Installation procedure is the reverse of removal, except for the following:
- Position all wiring around the housing and secure it as necessary with cable ties. Remove any excess tie.
-
Install a new back seal on the door handle assembly: