02/03/2020 13:50:14

Front Drive Unit (From Above) (Remove and Replace)

Correction Code 39012002

Informational PurposesAn informational icon, calling your attention
Note
If possible, use the "From Below" procedure to remove and replace the front drive unit (refer to procedure).

Transfer Components

  1. Drain the coolant from the old drive unit.
  2. Release the 2 bolts that secure the jackshaft to the old drive unit (torque 30 Nm).
  3. Remove all NVH padding except for the lower LH section.
    Informational PurposesAn informational icon, calling your attention
    Note
    This section of padding cannot be removed while the drive unit is supported by the crane.
  4. Open the crate that contains the new drive unit. Set the lid on the ground so that any padding is facing upwards.
  5. Lower the old drive unit onto the lid.
  6. Remove the crane cables from the drive unit.
  7. Remove the lower LH section of NVH padding from the old drive unit.
  8. Remove the coolant hose and pump from the old drive unit.
  9. Resecure the crane cables to the old drive unit and lift it off of the crate lid.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be very careful not to damage the motor in the next step.
  10. Working with at least 1 assistant, lift the new drive unit out of the crate and set it on the crate lid.
  11. Transfer the following components from the new drive unit to the old drive unit:
    • LH motor mount
    • RH motor mount
  12. Use the crane to place the old drive unit into the crate.
  13. Install all NVH padding except for the lower RH section onto the new drive unit.
  14. Secure the crane cables to the new drive unit and raise it.
  15. Install the coolant hose to the new drive unit.
  16. Install the 2 bolts to secure the jackshaft to the new drive unit (torque 30 Nm).

Installation

Installation procedure is the reverse of removal, except for the following:

Perform a full firmware update.