02/03/2020 13:50:14

Fascia Assembly - Rear (Remove and Replace)

Correction Code 10013002

Removal

  1. Remove the rear fascia for access (refer to procedure).
  2. Remove the bolts (x4) and plastic rivets (x2) that secure the diffuser tray to the rear fascia (torque 3 Nm).
  3. Release the clips (x15) that secure the rear fascia to the diffuser and applique.
  4. Remove the rear diffuser and applique.
  5. Disconnect the park assist sensor connectors (x4 or x6).
  6. Release the clips (x7) that secure the harness to the rear fascia. Remove the harness.
  7. Carefully release the park assist sensors (x4 or x6) from the rear fascia retaining rings.
  8. Carefully release and remove the sensor retaining rings (x4 or x6) from the rear fascia.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Care must be taken to avoid damage to paintwork and exterior trim.

Installation

Installation procedure is the reverse of removal, except for the following:

Check the alignment of the rear fascia to the body. Adjust as necessary.

Transfer all components from the old fascia to the new fascia.